> Is there any reason I shouldn't make a "Y connector" so my CW paddle
> can be input to the K3 and another radio (or external keyer)?
Yes. Most rigs have a logic level input with pull-up. Some are CMOS
(12V) others are TTL and all have some voltage that could cause
issues for another radio.
If you do a "Y" connection, at a minimum you should use diodes to
isolate the radios. However, if one of the radios uses low power
CMOS logic even a silicon switching diode will introduce too much
voltage offset for the keyer to work properly.
73,
... Joe, W4TV
On 3/27/2011 5:50 PM, Barry wrote:
> Is there any reason I shouldn't make a "Y connector" so my CW paddle can
> be input to the K3 and another radio (or external keyer)? Yes, only one
> will be on at any given time.
> Tnx,
> Barry W2UP
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
