I used two thin strips of duct tape. The tape supplied with my kit did not hold either.
Chuck K4QS --- On Thu, 4/7/11, Chuck Guenther <[email protected]> wrote: > From: Chuck Guenther <[email protected]> > Subject: [Elecraft] KX1 Red Display Filter > To: [email protected] > Date: Thursday, April 7, 2011, 7:49 AM > Instructions for installing the LED > filter are given on page 52 > of the latest KX1 manual (Rev. E, dated May 21, 2010). > > The transparent tape just didn't hold in my case, with the > result > that the filter is floating around inside the case > somewhere, leaving > the LED display chip exposed. > > Has anyone discovered a better way to attach this > filter? I'm thinking > of using a very small quantity of RTV sealant, judiciously > applied > around the edges of the filter with a toothpick. Any > thoughts? > > Thanks & 73, > > Chuck Guenther NI0C > KX1 s/n 2512 > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
