Geee,
I simply put rubber bands on the bail until the ends were close enough
together to install. Remove the bands one at a time. Took about 5 min.
Wayne, K9NE
K2 S/N 04858
----- Original Message -----
From: "Ken Bessler" <[EMAIL PROTECTED]>
To: "Elecraft Main Group" <elecraft@mailman.qth.net>
Sent: Thursday, June 02, 2005 3:37 PM
Subject: Re: [Elecraft] Installing the K2 TILT BAIL - The easy way!
----- Original Message -----
From: "Tom Hammond" <[EMAIL PROTECTED]>
To: " "RC" KC5WA" <[EMAIL PROTECTED]>; <elecraft@mailman.qth.net>
Sent: Thursday, June 02, 2005 3:13 PM
Subject: [Elecraft] Installing the K2 TILT BAIL - The easy way!
Hi Folks:
At 10:20 AM 6/2/2005, \"RC\" KC5WA wrote:
I have reached that portion in the RF Board Assembly
titled "Alignment and Test, Part I" on page 42. Everything
<snip>
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com