My experience is that the diagrams in the Elecraft manuals (and PCB
layouts) are intrinsically right-handed, and if you are left-handed as I
am and don't really study the task well, you are likely to wind it
backwards. For each new set of toroids I need to wind, I usually
practice a couple of times with some loose hookup wire to make sure I
still remember the moves.
If my memory serves me, there really is no such thing as a 1/2 turn ...
each pass thru the donut is a turn. But then, my memory serves me less
and less these days.
73,
Fred K6DGW
Auburn CA CM98lw
Jeremiah McCarthy wrote:
While we are on the subject of toroids, I would like to point out
> something I have encountered while up-grading pre-built K2's...
> toroids can be wound backwards, ...
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
