Please note that several pins must be broken off or removed so that not all signal lines are passed from K3 to the amp.
Eric www.elecraft.com _..._ On Jun 11, 2011, at 7:15 AM, "Phil & Debbie Salas" <[email protected]> wrote: > A good cable is the 6-foot SVGA M/F cable from www.cablewholesale.com, part > number 10H1-01206. All 15 pins are connected through, no pins are shorted > together, and there is a foil shield with drain wire - and the cable is only > $3.25. Here is the spec sheet on that cable: > www.cablewholesale.com/pdfspecs/10h1-012.pdf. > > So for non-K3 users, just cut off the male end and connect your > radio-specific connector. For K3 users, you can just remove the unnecessary > male pins (use needle nose pliers to twist and pull out). Or you can use a > 31H1-05200 HD15 M/F adapter ($1.76) and break out the pins on this M/F > adapter should you wish to preserve the cable as-is. > > Cable Wholesale also sells a SVGA splitter (2xfemale-to-male) with all pins > connected through. Part number is 10H1-27708 and these are $3.46 each. > > I have no connection to these folks, other than I've been using their cables > and adapters. > > Phil - AD5X > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
