Thanks Steve that did it. I don't need the mic up and down buttons so disabling them in the K3 config was the answer.
73 Jeff kb2m -----Original Message----- From: Steve WU9B [mailto:[email protected]] Sent: Saturday, June 18, 2011 16:08 PM To: Jeff KB2M Subject: Re: [Elecraft] K3 with Kenwood MC-60 Try Config: MIC BTN OFF (as opposed to ON) 73, Steve WU9B On Jun 18, 2011, at 12:39 PM, Jeff KB2M wrote: > I picked up a used MC-60 mic at Dayton. When I try to use it with my K3, > as soon as I connect it via the 8-pin foster on the front the frequency > starts to scan like I'm holding down the up button on the mic. Thinking that > there was a problem with the mic I tested it with a Kenwood TS2000 and it > works perfectly. You push the up button and it scans up, etc. Now what > puzzles me is that I used to own another MC-60(that I sold) and it worked > correctly with my same K3. I'm wondering what could be causing this before I > start to take everything apart. Anyone else run into this, does anyone have > any ideas? > > 73 Jeff kb2m > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
