The Signalink USB has an internal jumper for high or low output. 73 Greg AB7R
On 7/11/2011 8:37 PM, Don Wilhelm wrote: > Tom, > > I do not know whether the SignaLink is one of those that provide only > mic level output, or if it is one that has provisions for Line level out. > > In any case, it would appear that you are not getting enough audio drive > level to the line-in jack of the K3. Can you drive the audio up to the > required 4 to 5 bars indicated on the ALC meter? If not, there is not > enough audio to the K3. > > Check the SignaLink documentation to see if there is a jumper that > allows line level output. Most default to microphone level, and for > line level, you need a signal 50 to 100 times greater than microphone level. > > 73, > Don W3FPR > > On 7/11/2011 11:00 PM, n...@n5ge.com wrote: >> I'm setting a SignaLink USB up on my K3 and am having trouble getting it to >> transmit. >> >> The rig is keying and the TX LED is lighting but I'm getting no power out. >> >> I'm connected to the LI/LO and PTT on the rear of the rig. >> >> I'm receiving well in DATA A mode On Main Menu MIC SEL is set to Line In. >> >> Any one have a check list I can follow? >> >> 73, >> Tom >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
