Thanks, guys! It was the mic gain and it's working now, but it is a bit low (gain is all the way up), so I'll install the jumper in the SignaLink tomorrow after I play with it a while tonight ;o)
Best to all, Tom On Mon, 11 Jul 2011 20:41:53 -0700, Greg <[email protected]> wrote: >The Signalink USB has an internal jumper for high or low output. > >73 >Greg >AB7R > > >On 7/11/2011 8:37 PM, Don Wilhelm wrote: >> Tom, >> >> I do not know whether the SignaLink is one of those that provide only >> mic level output, or if it is one that has provisions for Line level out. >> >> In any case, it would appear that you are not getting enough audio drive >> level to the line-in jack of the K3. Can you drive the audio up to the >> required 4 to 5 bars indicated on the ALC meter? If not, there is not >> enough audio to the K3. >> >> Check the SignaLink documentation to see if there is a jumper that >> allows line level output. Most default to microphone level, and for >> line level, you need a signal 50 to 100 times greater than microphone level. >> >> 73, >> Don W3FPR >> >> On 7/11/2011 11:00 PM, [email protected] wrote: >>> I'm setting a SignaLink USB up on my K3 and am having trouble getting it to >>> transmit. >>> >>> The rig is keying and the TX LED is lighting but I'm getting no power out. >>> >>> I'm connected to the LI/LO and PTT on the rear of the rig. >>> >>> I'm receiving well in DATA A mode On Main Menu MIC SEL is set to Line In. >>> >>> Any one have a check list I can follow? >>> >>> 73, >>> Tom >>> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
