I guess you know that it is NOT recommended to try and remove the flux from the boards after construction... if you don't get every bit of it off after you dissolve it with whatever solvent you're using, you'll end up with a severely contaminated board and future problems with it. If you have used quality solder as recommended by Elecraft, there should be no reason to apply extra flux during construction nor any reason that you would need to clean the board after soldering.
Just my $0.02 de AJ4TF -- View this message in context: http://elecraft.365791.n2.nabble.com/k2-Poor-USB-audio-after-cal-tp6616641p6616993.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
