David, Sorry to be crass, but if you do not understand ">" (greater than) or a range of allowable resistances, I cannot be of much help. I examined the first 6 of your readings and found them to be within the values that are specified in the manual. I do not desire to go any further and check all your measurements. If you have readings that are out of the range listed in the manual, then I will certainly be responsive, but in those forst 6 readings, all seems to be OK.
73, Don W3FPR On 8/7/2011 9:34 PM, David Dietrich wrote: > Evening Everyone, > > I am totally done with the control panel, and right at the resistance check > part of the front panel on my K2. On some of my readings, I am not getting a > reading at all. I have a Meterman multimeter. When the probes are crossed, > 0.4 or 0.5 Ohms are considered "zero" or "ground" on my meter. I am getting > some infinite readings on my meter, even on the 2000k Ohm setting. I just > get a "1" at the beginning and nothing else...I am guessing that is infinite. > I checked the board for unsoldered components, solder bridges, and the like, > and found nothing. > > Here are the readings I am getting on both boards. Could someone verify that > my numbers jive with what I should be getting? > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
