Ken, All good points and must be done to take full advantage of the KPA's capabilities. The V1.11 threw me too. I have been communicating with Elecraft on a separate issue on the K3/PR6/KPA compatibility and they have noted the highest (Non Released) Version is 1.09. I even checked earlier this AM to see what was actually on the Elecraft Site as far as Firmware Download Version and it is "still" as V1.02. This is what my KPA came with about two weeks ago. I do not know where the 1.11 came from unless Elecraft generated another Beta Version and sent it out seperately.
Good comments... 73's Richard Griest - WB4VMH On Aug 13, 2011, Ken Wagner K3IU wrote: And... make sure the K3 CONFIG:PWR SET is on Per Band. Does the KPA500 really have Firmware version 1.11??? 73, Ken K3IU ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ On 8/13/2011 6:42 AM, Ken Wagner K3IU wrote: > Make sure that you turned on the Aux > Bus in the KPA menu. > 73, > Ken K3IU > > On 8/12/2011 11:41 PM, D Joyce wrote: >> Group: I'm checking out a recently >> completed KPA500 (#234) running FW >> V1.11 with a K3/10 running FW Ver >> 4.36. The K3/100 with which it will >> eventually be used is otherwise tied >> up and I wanted to confirm the the >> per-band power control feature when >> used with the K3. (I'm using the AUX >> interface cable.) >> >> It doesn't seem to work as described >> in the KPA500 Owner's Manual Rev B - >> see page 9 Item 4 under >> Transmitting. If I put the Amp in >> Standby and set the K3 for 5 W as a >> low power level and then turn the Amp >> to Operate and run the K3 up to a >> drive level of about 8 W to produce >> about 100 Watts from the KPA500, then >> when I turn the Amp back to Standby >> the power level is 8 W not 5W. >> >> Perhaps the per-band power control is >> dependent on using a K3/100 not a K3/10. >> >> Anyone else seeing the same thing? >> >> 73, Doug VE3MV >> >> >> >> >> ______________________________________________________________ >> >> Elecraft mailing list >> Home: >> http://mailman.qth.net/mailman/listinfo/elecraft >> >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:Elecraft@mailman.qth.net >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: >> http://www.qsl.net/donate.html >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html