Alan, That sounds like you tuned down from 40 meters to the 80 meter band, and the VFO could go no lower than 11038 MHz. If so, it is easy to fix - just do a direct frequency entry to any frequency in the 80 meter band.
If that does not fix it, then check the soldering on RF Board C72. Another possibility is a bad relay at K13, but if all other bands are OK, then the relay is quite low on the suspect list - but check the soldering at K13 pin 4 since that pin only switches in C72, 73, Don W3FPR On 9/6/2011 8:33 AM, Alan Davenport wrote: > Good Morning Don, > > Well it certainly looks like it is a VCO issue. On all bands except > 80m, it is working correctly however on 80m here are the results: > > 3.5 MHz = 11038.61 MHz > 4.0 MHz = 11038.51 MHz > > Subtracting 4913 KHz gives me ~ 6125.6 KHz. > > No wonder 80m isn't working. What surprises me is that this issue is confined > to just one band. What is your suggestion on what to check? > > Thank you again Don, > 73 de Al, W2GZN > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
