Could be intermittent contact between the Front Panel module and the RF board. Try loosening all the screws on the FP module, backing it out 1/8th inch or so, then plugging it back in.
73, Wayne N6KR On Sep 10, 2011, at 1:02 PM, cx...@4email.net wrote: > Hello, > > I have been away for 3 months. The K3 was completely disconnected from > antennas, power supply, including removing the PP from the back of > the rig. > Today I decided to update the firmware and when I turned the power > on, I > got err BP1, then LPF, IO3, IF1, XV3, AT3, PA1, and BP3. After that, > it > worked fine. I hooked it up to dummy load and got full power on all > bands...turned it off, same result, BP1, LPF, etc. I could use any of > the rocker switches/buttons on the front panel and any of them would > cycle to next error msg, in the same order as the first time..then > work > ok. I had an older firmware so decided to put 4.39 in the radio, along > with the DSP1/DSP2. AFter the successful download, same thing....power > up....BP1, LPF, etc. > > Any ideas, suggestions? > > 73 > Tom > CX7TT > P.S. K3 #250, factory built...3 times back to the factory, so far.... > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
