So I accidentally skipped the first page of instructions then found that I had some parts left over at the end of construction and I was missing the header P1 or whatever, so I grabbed the connector and soldered it in....only to find that the previous owner of my K2 had already put the female connector on the main board of the K2, and I had just accidentally installed the female connector on the KSB2 board. Great.
Long story short, I ripped out the female connector on the main board as it was much easier to access but it was a huge **** to get the male header into the holes. It isn't quite seated all the way but it is stable and straight and seems to work OK with the module installed. Question is: how would one actually go about removing one of these headers correctly (I guess I already know the answer: desoldering station) Already have 1 5w SSB qso down with one of the RT 66 stations and sent 1 wspr tx this morning and was spotted several places on the East coast. It works! :D TJ W0EA ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
