Many thanks to Dave, Harry, Mike MU, Mike MK, Mark and Matt for the information.
Everyone agrees that I should pay very close attention when re-mounting the Front Panel. Also to clean the pins before re-assembly. I have had no problem with bad connections but will be sure to dress them up before putting it all back together. Again many thanks to all, Earl N5ZM.. On 9/26/2011 4:18 PM, Earl wrote: > Hi All, I just received my K3DSPUPGD board. My K3 (#3223) is a Factory built > unit. Therefore I have no experience at dismantaling and re-assembing the > radio. I have an Anti-Static Mat and Wristband and the Elecraft instructions > seem to be very clear. I did follow the recent thread about grounding/ESD > protection and keeping everything at the same potential while handling the > PCB's. > > My question, is there anything in particular that I should be aware of doing > this change out that may not be as clear as it needs to be for a beginner? > > TIA, 73 Earl N5ZM > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- In every walk with nature, one receives far more than he seeks. John Muir.. ------------ Earl F. Smith - N5ZM PO Box 20065 White Hall, AR 71612-0065 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
