Don, just press TUNE as Dennis noted. The K3 will transmit a carrier at the initial level set in CONFIG:TUN PWR menu. Once you press TUNE, you can adjust the RF output of the K3 to anything within its range from almost zero to 100 watts by turning the PWR knob.
Ron AC7AC -----Original Message----- Dear Group. I need to figure out how to send a simple tone output from the K3 to my amp to be able to check power output. I dont have a CW keyer and can not figure out how to set up a simple switch to key a tone. I ultimatly want to plot K3 drive power to amp output power for each of the bands. I am sure if I had a CW keyer it would be easy, but I was hoping I could do something with a simple rocker switch. I am sure there is a way to do it. Thanks Don ~73 Don KD8NNU ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
