Hi Jim, Good question. While I have been troubleshooting the KPA I have left the KAT100 out of circuit - I don't need it while transmitting into a dummy load. The AT-200 has a straight through mode for power measurement that I am using. I only borrowed the AT-200 for power meter as the KAT100 is excellent :).
Mike VK1KCK K2 #2599 -----Original Message----- From: k4zm [mailto:[EMAIL PROTECTED] Sent: Wednesday, 29 June 2005 9:44 AM To: Mike Walkington Subject: Re: [Elecraft] RE: K2 and KPA 100- How Is Hi Current Generated Don: Do you have the Kenwood AT-200 installed between the KPA100 and the KAT100 or beween the KAT100 Output and the antenna? If connected on the output of the KAT100 you cannot expect to see an accurate SWR/POWER indication on the AT-200. 73 Jim Younce K4ZM K2 SN: 18 _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
