Note that the CWT indicator range, upon which the autospot function is based, is only about 200 Hz wide. In 100 Hz step mode, you'd have to be less than 1 step away from zero beat for the function to work.
73, Lyle KK7P > I'm using 4.39. I just tested it to double check my previous statement. > In 10Hz tuning mode it IS changing to 1Hz mode and tuning properly. In > coarse tune mode (100 Hz), it is not changing tuning rate. I withdraw my > statement about the 10Hz but stand by the 100Hz. > > Thanks for making me check! > > 73, Dennis NJ6G > > > On 10/19/2011 3:57 PM, Greg wrote: >> What firmware version is being used? When using the auto tune >> function the radio should go into fine tune mode and then turn it off >> after the tuning is done. >> 73 >> Greg >> >> >> On Wed, Oct 19, 2011 at 3:52 PM, Dennis Moore<[email protected] >> <mailto:[email protected]>> wrote: >> >> Others have mentioned the Autospot feature, and here's an >> observation on >> that as it relates to your issue of a large freq change. >> >> If my freq resolution is at 10Hz or 100Hz and I try to Autospot, I >> will >> get a 2kHz shift as you described. If, however, I am set to 1Hz >> resolution, the Autospot feature brings the frequency right where >> it is >> supposed to be. >> >> 73, Dennis NJ6G >> > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
