Hello everyone,
I am sure there is a simple and thoroughly obvious answer to this but I
haven't found it. I have a K3 connected to a Signalink USB interface. I am
using the specific K3 cable that plugs in to the speaker and mic jacks on
the K3. I believe I have the internal jumpers on the Signalink set
properly. I have adjusted the sound card levels as recommended.
I can receive everything and decode signals just fine using Ham Radio
Deluxe. I just can't transmit any digital modes. I have tried many
combinations of settings with no luck. The K3 goes into transmit but I get
no indication of RF output. It works fine on CW and SSB.
What am I missing? Thanks in advance.
Doug W4DAS
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
