Hi Guys
I did not assemble my K2 (no 4099) which I bought second-hand and I now wish to use a ProSet K2/K3 I have bought from Elecraft. According to the instructions which came with the ProSet , (Step 1) I have removed the 4 exterior screws securing the K2 front panel to the front of the K2 case. They also say "remove the two interior screws holding the control board to the front panel board". Where exactly are these 2 screws, and what else do I have to remove to get at them please? So far I have removed the top, bottom & right side of the chassis, located the Control Board & the front panel board but I'm not sure what I need to do next.. Any help appreciated 73 Ray, G3XLG ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
