A friend of mine here, who does not have an Internet access, have a
basic K2 that show only 5V on the display instead of 12.X or 13X
Volts. He does not have the battery option. But everything is working
fine, TX, RX, etc.. The K2 is powered on a good 13.8V Motorola power
supply.... His jumper on the control board is set to 12V, but the
display always show 5V and he also get a "low batt" message at every
couple of minutes....
Where he should look ???
73
======
Jean-François Ménard / VA2VYZ
======
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
