JEAN-FRANCOIS MENARD wrote:
A friend of mine here, who does not have an Internet access, have a
basic K2 that show only 5V on the display instead of 12.X or 13X Volts.
He does not have the battery option. But everything is working fine,
TX, RX, etc.. The K2 is powered on a good 13.8V Motorola power
supply.... His jumper on the control board is set to 12V, but the
display always show 5V and he also get a "low batt" message at every
couple of minutes....
Where he should look ???
One place is R9 and R10 on the control board -- make sure they are the
correct values.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
