Mike, Assuming that all components are the correct value and are well soldered (worthy of a double check), then --- The most likely problem is that the Pre-Mixer bandpass filter is not tuned to the correct frequency.
Do you have a signal generator capable of producing a signal on 40 and 20 meters - Another transceiver working into a dummy load and a piece of wire on the K1 for an antenna placed near that dummy load should produce a good signal into the K1. Do you have a 'scope or an RF Probe? If so, you can tune the Pre-Mixer bandpass filter using that to observe the output at P1 pin 6 on the 2 band board. Tune the inductors for maximum voltage. 73, Don W3FPR On 12/24/2011 6:21 AM, Michael Moody wrote: > Hi all, > > New builder here having troubles with no receive during alignment of > the receive section. Here are the details: > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
