I get the following error when trying the 1 mW calibration for a freshly installed KXV3A:
Starting 1 milliwatt calibration. Calibrating at 1.900 MHz IsSamplingComplete: Unexpected response 'DB 0.10 MW;' to ''. State 220 Calibration power settled at ' 0.10 MW;' 1 milliwatt calibration failed. Elapsed time: 19.2 secs K3util is 1.4.1.8 for linux. The dummy load is a tiny 50 ohm one directly made out of a bnc. I've measured it at 51.8 ohm which, given that the reading with the probes shorted is 1.5, is as close as I can get. Another bigger dummy with some adapters and short cables gives the same error. I'd tend to rule out the dummy load as the culprit. Ideas? Pf -- Pierfrancesco Caci, ik5pvx ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
