I do have the same problem with TX Gain Calibration, 5w and 50w calibration goes well, but 1mW calibration fails, I am getting the error something like: "Power set to 0.1 mW, 1.9 MHz, TX gain calibration failed because transmit power did not reach the expected value".
I did reload FW, EE INIT, settings restore, nothing helps. KXV3A is enabled and set to normal in config, no jumpers on W1 and W2, 50 Ohm dummy load on XVTR Out is OK. XV144 does not work properly, I believe that is connected with XVTR Out problems. XVTR parameters in config are set correctly. Any ideas? 73 Robert 2012/2/12 Don Wilhelm <[email protected]> > Did you forget to cut the jumpers when you installed the KXV3A? > > 73, > Don W3FPR > > On 2/12/2012 11:22 AM, Pierfrancesco Caci wrote: > > I get the following error when trying the 1 mW calibration for a freshly > > installed KXV3A: > > > > Starting 1 milliwatt calibration. > > Calibrating at 1.900 MHz > > IsSamplingComplete: Unexpected response 'DB 0.10 MW;' to ''. State 220 > > Calibration power settled at ' 0.10 MW;' > > 1 milliwatt calibration failed. > > Elapsed time: 19.2 secs > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
