Hi Paul, I have the same issue. It just happened some time ago so I traced the PH_SW signal down to U8 pin#9. PH_SW acts as intended so either U8 input is faulty or it is in FW.
Jan SM6TUW Paul Ormandy ZL4PW wrote > > Hi all, > > Further to the earlier issue... i.e. my K3 is in "SPKR+PH - On" mode even > though the rig says it is > off. > > This only occurs thru the front speaker port. > > When I plugged the phones into the rear socket, the internal speaker cut > out and I have the usual > sound from the rig... > > I would still like to fix the front phone socket issue as it is much more > convenient for me to > revert to Speaker from that position. > > This curious behaviour occurred overnight... it was fine when switched off > yesterday and appeared at > switch-on today.. I did not access the menus for any reason. > > I wonder if a firmware re-install may correct it??? > > Cheers, > > Paul > > -- View this message in context: http://elecraft.365791.n2.nabble.com/SPKR-PH-fault-tp7343627p7344090.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
