Sit in my shack with all the PC equipment, supplies and monitors running... what a noisy mess. When we had a major power outage and I was on my backup battery the noise floor was so low I had to adjust the ref level on the P3. Gives one great cause to pack up and go portable. Great reason for one of the Elecraft portables, esp. my FT #12 KX3. Now to get the time to get out of here.
73, Bill K9YEQ -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Jim Brown Sent: Thursday, March 29, 2012 4:22 PM To: [email protected] Subject: Re: [Elecraft] P3 SVGA On 3/29/2012 2:11 PM, Adrian wrote: > Sorry Phil, my bad, however a good one will have ferrite molds built > on the cable for suppression etc. of course. Not really. All that ferrite does is get the mfr under the VHF/UHF limits EMI test lab. It does NOTHING for RF interference below about 100 MHz It takes lots of turns through #31 or #43 to make a dent on the HF bands. 73, Jim Brown K9YC ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
