Dave, Your best chance is to look carefully at the thermistor board - such problems usually originate there - it is easy to create a solder bridge on that small board. You can often spot it by removing the front panel and control board and peek at the solder side of the board - if not, removal is the best way to check it, but then you have to solder on new wires to re-install it.
73, Don W3FPR > -----Original Message----- > > I have started carrying out Alignment and Test, Part2 & have hit a snag. > > It says that the frequency reading in the VCO test should be in the 8 to > 10 MHz range. Mine is stable at 7.726MHz & the manual says refer to > troubleshooting. Where in troubleshooting? > > Also I don't read 6V at R30 when tuning L30. Voltage seems to be in mV & > doesn't change. Should I examine all the parts surrounding the VCO? > > Dave Lindsay, GM4HQF > > -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.0.338 / Virus Database: 267.9.7/60 - Release Date: 7/28/2005 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
