The K3 Utility doesn't know the KPA3 is there unless you enable the KPA3 configuration menu selection.
Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Dave (K7DRT) Sent: Saturday, April 07, 2012 8:53 PM To: [email protected] Subject: [Elecraft] Cannot get to "Config" menu after installing KPA3 I just finish assembling my K3/100. All went well until that last step of installing the KPA3. Now if I attempt to go to the CONFIG menu the radio beeps (It cycles from normal to main). The config menu never appears. I updated firmware using the K3 Utility. The problem still exists. The utility transmit calibration menu has the 50 watt test not highlighted (not available). I will look at responses to this before pulling the KPA3 out. Thanks and 73, Dave (K7DRT) Tucson, Az. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
