Jeremy Cowgar wrote:
Sorry, user error with a bit of panic.... I don't know how I did it,
but I installed C10 (bottom of the board) into C38's position. C10 is
a 10uf electrolitic on the output of U9 to ground. That fixed it all,
now I just hope I didn't blow up U3.
Ah, I think I'm alright. U3 is a TC4427 which mouser says is a Dual
High-Speed Power MOSFET Driver. It's spec sheet says: Wide input supply
voltage operating range: 4.5v - 18v. Mouser has a pretty cool site I think.
Thanks,
Jeremy
KB8LFA
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
