Just to be sure; Did you try the Ref Lvl adjustment? On 5/3/2012 3:50 PM, Ralph Parker wrote: > Well, more-or-less fixed. > W4TV was the first to suggest setting all the RS-232 rates to 38400, and > now the communications problem is fixed. Hooray!! > Now to download the new firmware (it came with 1.13). > > One last problem: > The IF display is off the bottom of the screen - I can only see the peaks > of the stronger signals (and not 7O6T). > I just did the IF output gain mod, and at one point the displayed spectrum > rose above the baseline, but it's gone back down again. I don't seem to be > able to find a setting that would change the 'vertical position' of the trace. > While adjusting the "SCALE", the trace pops up for a second or so, then > disappears back down again. > > Tnx for all your help. > > Ralph, VE7XF > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > >
-- Rowland R Johnson [email protected] www.lascanadas.org House 805-438-3673 Cell 805-305-5252 Fax 805-438-4970 ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
