Joe, I have done many of them, and while soldering "down in the hole" to the connector pin is a bit of a challenge, I have not found a better way. Do not try to put the wire through the hole in the lug, it is adequate to dress it along the side of the lug (make sure it is touching) and solder with a slender tip.
73, Don W3FPR On 5/4/2012 2:56 PM, [email protected] wrote: > I just finished assembling my first KX1 paddle. Wiring the paddle boards to > the installed 3.5mm phone plug was challenging to say the least. Has anyone > figured any practices to make this easier? I think there may be a second KX1 > in ,my future and I want to be prepared. > Thanks. > Joe > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/wiring-the-KX1-paddle-tp7528281.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
