If I remember correctly, microHAM specifically advises *against* connecting like that and doing updates through the microHAM device. It would seem prudent to disconnect your microHAM device and directly connect your P3/K3 combination and effect updates in that manner.
Art - N4PJ On Mon, Jun 4, 2012 at 12:27 AM, Bob - W6OPO <bob.w6...@gmail.com> wrote: > Plug the USB cable that is connected to the MicroHam Keyer into the PC. Be > sure you have installed and run Router defining the necessary port numbers > for all the features in the microKeyer you intend to use. > > The big cable that you plugged into the back of the microKeyer with all the > seperate leads you hooked up to the K3 - one of which is the serial > interface (RS232). Now the communication between the PC and K3 is via the > microKeyer. Works fine but for one task...FW updates. > > Be sure to note in the manual about not trying to do any firmware updates > in > this configuration. You MUST plug the K3 directly into the PC for these > updates. Believe me, as the manual says, it does NOT work with the > microKeyer in the middle. > > All information is pretty clear in the MicroHam manual. > > 73, > > Bob - W6OPO > > -- > View this message in context: > http://elecraft.365791.n2.nabble.com/K3-P3-Microkeyer-tp7556989p7557038.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
