I would recommend replacing the amp relay with a faster one or pin diodes as a real fix but if you just want VOC CW you can lengthen the VOX delay so that the VOX does not drop between characters.
Sent from my iPhone On Jun 8, 2012, at 12:25, "Vic, K2VCO" <[email protected]> wrote: > No, it's not that simple. Just try it in TEST mode and see. > > On 6/8/12 3:02 AM, Jim Brown wrote: >> On 6/7/2012 10:01 PM, Vic K2VCO wrote: >>> The problem is that the K3 does not produce good CW when the TX delay is >>> set to more than >>> about 14. Nothing to do with QSK in this case. >> >> Hmmm. I have no experience with this (because my Ten Tec Titan amps work >> fine with default settings), but might this be fixed by using something >> like a WinKey and tweaking the weighting? >> >> 73, Jim K9YC >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> > > -- > Vic, K2VCO > Fresno CA > http://www.qsl.net/k2vco/ > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
