I just swapped the sub rx from one K3 to another. With the right side panel removed, the aux BNC is right there and you can use a small 7/16 open-end wrench to tighten the nut. Cheers and 73,
Fred Cady "The Elecraft K3: Design, Configuration and Operation" www.ke7x.com fcady at ieee dot org > -----Original Message----- > From: [email protected] [mailto:elecraft- > [email protected]] On Behalf Of Erik Basilier > Sent: Friday, June 22, 2012 11:34 AM > To: [email protected] > Subject: [Elecraft] K3 Quickest way to access loose AUX RF nut > > Just pulled my K3 off the operating shelf for travel to Field Day. > Discovered that the AUX RF BNC connector is quite loose. Started to > loosen > adjoining case panels to tighten the nut, but didn't find a way to > easily > get at the nut. Since I don't need this connection for FD, and I don't > have > time to spend, I will just defer fixing the problem until I get home. > However, if there is a best way to do the job, without removing the > second > RX etc, I'd like to know. Any advice? > > > > Thanks and 73, > > Erik K7TV > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
