Don - I have not been following this thread very carefully, but am a bit baffled by your response to Keith. He talked about not getting a "solid click" when plugging the DC cable into the back of the K3... it sounds like you are talking about the "click" when inserting the terminal into the APP.
I have NEVER had a "click" when plugging a power pole into another power pole, whether on the rear of my K3, or in-line. In fact, the power poles disconnect from the rear of the K3 with such ease that if I move the rig, even a little, I OFTEN have to plug the DC back into the rear of the K3. I thought that perhaps I did not understand what you were telling him, so I looked at the XV download link you referenced, and cannot find the diagram to which you make reference. Dave - K9FN On Sun, Jul 29, 2012 at 12:22 AM, Don Wilhelm <[email protected]> wrote: > Keith, > ..... > > If your APP connectors do not fit together and "latch" in place, it is > likely that you have not assembled them properly. Take a look at the > diagram on page 37 of the XV transverter manual Download from > > http://www.elecraft.com/manual/XV%20Transverter%20Owner%27s%20Manual%20Rev%20F.pdf > . > > Figure 29 is the best description of the proper locking of the APP > blades into the housing. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
