A drop of DeOxit on it [shield and center pin, both ends] and several removal/insertions cured mine. Also, make sure the P3 chassis screws are tight, and the chassis is directly bonded to the K3. I may put a ground post on my P3 to take it to the ground bus right behind the rigs.
The other note is that I originally ran without the K3 IF Level mod, and when I calibrated the P3 and K3 S-Meter with my service monitor, I ended up with fairly high gain in the P3, and quite a few anomalous blips and such. Doing the mod got the gain back to normal and all is well. 73 Fred K6DGW On 8/1/2012 3:08 AM, Jack Berry wrote: > I saw this for the first time a few weeks ago. Check your BNC connections - > just open and close the twist on connector, maybe even pull is off and > reinsert. That killed my birdies. It's happened a few times. > > Whether or not this is a common problem, I don't know. > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
