Looked on Amazon and there are eleventy-eight kinds of Deoxit. Which is the right one?
On Jul 31, 2012, at 11:19 PM, FredJensen <[email protected]> wrote: > A drop of DeOxit on it [shield and center pin, both ends] and several > removal/insertions cured mine. Also, make sure the P3 chassis screws > are tight, and the chassis is directly bonded to the K3. I may put a > ground post on my P3 to take it to the ground bus right behind the rigs. > > The other note is that I originally ran without the K3 IF Level mod, and > when I calibrated the P3 and K3 S-Meter with my service monitor, I ended > up with fairly high gain in the P3, and quite a few anomalous blips and > such. Doing the mod got the gain back to normal and all is well. > > 73 > > Fred K6DGW > > On 8/1/2012 3:08 AM, Jack Berry wrote: >> I saw this for the first time a few weeks ago. Check your BNC connections - >> just open and close the twist on connector, maybe even pull is off and >> reinsert. That killed my birdies. It's happened a few times. >> >> Whether or not this is a common problem, I don't know. >> > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
