rowland wrote > > On my P3 the BNC connector problem caused signals to be presented on the > P3 display > that could not have been present at the antenna. The P3 showed two bands > of increased noise floor that were each roughly 38 kHz wide. One was 62 > kHz above center freq and the other was 62 kHz below center freq. These > noise bands were always present, regardless of operating band or center > freq, with the same width and at the same distance from the center freq. > If you're seeing signals invariant of the center freq then try a > different BNC cable." >
I had the same issue as you describe, and fixed it by swapping to another cable. The poor connection was at the P3 side of the cable. Once swapped out, I also found that my USB sound card was radiating a lot of noise as well. I had to both swap cables and unplug the sound system to get to a nice flat display. -- View this message in context: http://elecraft.365791.n2.nabble.com/P3-hash-tp7561251p7561349.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html