I'm in the process of setting up a remote K3 Twin Station, and am having a few minor problems. I'm addressing this to the Elecraft reflector as I think the problems are correctable thru the K3 setup.
1. Is there a software command that will put the Control K3 into Terminal mode? I know I can do it by pushing and holding in the CONFIG key, and I've been over the Programmers Reference but don't see either a software command or a <Long Hold> key # that will do it. I also don't see anything in the Firmware Update Section on how to do this. 2. If my Control K3 is in Terminal mode, I'm connected to the remote unit, I then turn my Control K3 off, do something else, and come back an hour later and turn my Control K3 on (and it connects again), the audio on my Control K3 is now on. The noise is adjustable via the Control K3 volume control, but there its just noise- just no audio. If I take the Control K3 out of Term mode to Norm mode, the audio is again muted. How can I mute the local audio when I turn on the rig? Again, I searched through the most current Programmers Reference on the web, but can't find a software command to mute that audio, and if I did, I would probably mute the audio at both the Control and Remote K3s. The Firmware update area just says the Control K3 audio will be muted. Dennis W1UE ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
