On Wed, Sep 19, 2012 at 3:12 PM, Dennis <[email protected]> wrote:
> Thanks for the Reply. Your tip on the K3 was almost right on- I
> found that all you have to do is turn the AF to minimum while
> the Control K3 is off. Then, when you turn it on, the Control K3
> reads the minimum setting and the audio from it never comes on.
>
> I tried the RRT; and RRN; using a CAT command in N1MM. Neither
> seems to work, and both lock up the Control K3 and I have to
> power cycle it to restore it. I also don't see those commands
> documented anywhere.
Sending RRT; to the control K3 will put it in terminal mode, but it
will not put the remote K3 in Remote mode, so the control K3 will
appear to hang, as it's now waiting for RR commands that are not
coming. I don't know if there's any way to get the necessary RRR;
command to the remote K3 from your local N1MM Logger instance....
73,
~iain / N6ML
> On 9/19/2012 11:29 AM, Brandon Hansen [KG6YPI] wrote:
>> Hello Dennis,
>>
>> Yes, there is a serial port command to switch the radio between
>> Terminal and Normal mode. ("RRT;" and "RRN;")
>>
>> It is recommended to have both volumes knobs turned all the way down
>> when powering down the remote and control K3. This way on power up,
>> you will not have excessive audio coming from the remote and the
>> control K3 will already be muted.
>>
>> I hope this information helps.
>>
>
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:[email protected]
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
