Keith, I cna perhaps help with your inability to get 4 bars on the ALC meter with the 5th bar flickering - not that the 5th bar indicates the onset of ALC, those bars below the 5th are an aid to setting the proper audio level.
I suspect you are connected to the K3 Line In jack. That means it needs line level audio, and your MicroHam is probably still plugged for microphone level. Refer to the MicroHam documentation and change the jumper to increase the audio level. I would like to also point out that the proper audio drive level is quite important for the K3. Ignore the usual advice that tells you to adjust the audio to control the power output - that will result in poor power control of the K3. Set the audio level to 4 bars solid 5th bar flickering and then use the power knob to set the desired power level. 73, Don W3FPR On 9/22/2012 8:27 AM, Keith Heimbold wrote: > I am going to send this out to both reflectors, Elecraft and MicroHam because > I am not sure where I have set up the system incorrectly. The system does > work intermittently and I have had successful QSOs with it on both CW and > digital modes. > > Setup; K3, MicroHam USB 3, Y cable to ACC to USB 3 and Yaesu Quadra amp, new > Asus PC running 64 bit win 7 O/S with 12 gigs of RAM. > > Issue: I have intermittent performance with the USB 3 and my k3. At times > when using the device with FLDigi software the transceiver ends up locking up > on transmit and I usually have to exit out of FLDigi to stop the transmit > cycle as none of the buttons will work. This has happened in all fldigi > digital modes but is most prevalent during CW. > > I am also very uncertain about the knob position on the front of the USB 3. > Sorry but I can't find where the position should be in the manual. Plus I > cannot seem to get five bars on the ALC meter of my K3 no matter what I try. > > I am not sure if this is a K3 or USB 3 setup issue. I need a little help. It > does work about 50% of the time. > > Thanks, > > Keith > AG6AZ > > Sent from my iPhone please excuse typos > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
