Hi Martin, I decided to take a break in troubleshooting for another weekend and enjoy the fact that I got the USB III working well with fldigi for CW.
I will get back to it next weekend and drive towards some type of resolution. Thanks again, Keith AG6AZ Sent from my iPhone please excuse typos On Sep 22, 2012, at 1:07 PM, "Martin Storli - LA8OKA" <[email protected]> wrote: > Hi Keith. > > Have you tried without the Y-cable? > Have you tried with lower output? > I think that either the Y-cable is messig up things, or that you have an RFI > problem. > > There are no definitive answer of what the positions on the volum knobs on > the front shall be as they have to be adjusted depending on the software > used, the soundcard settings and the transceiver used. > > Martin Storli > LA8OKA > Oslo, Norway > > ARCTICPEAK's Radio pages! > http://www.arcticpeak.com/radio.htm > > Fra: Keith Heimbold <[email protected]> > Til: Elecraft Group <[email protected]> > Sendt: Lørdag, 22. september 2012 14.27 > Emne: [Elecraft] K3 and MicroHam USB 3 issue > > I am going to send this out to both reflectors, Elecraft and MicroHam because > I am not sure where I have set up the system incorrectly. The system does > work intermittently and I have had successful QSOs with it on both CW and > digital modes. > > Setup; K3, MicroHam USB 3, Y cable to ACC to USB 3 and Yaesu Quadra amp, new > Asus PC running 64 bit win 7 O/S with 12 gigs of RAM. > > Issue: I have intermittent performance with the USB 3 and my k3. At times > when using the device with FLDigi software the transceiver ends up locking up > on transmit and I usually have to exit out of FLDigi to stop the transmit > cycle as none of the buttons will work. This has happened in all fldigi > digital modes but is most prevalent during CW. > > I am also very uncertain about the knob position on the front of the USB 3. > Sorry but I can't find where the position should be in the manual. Plus I > cannot seem to get five bars on the ALC meter of my K3 no matter what I try. > > I am not sure if this is a K3 or USB 3 setup issue. I need a little help. It > does work about 50% of the time. > > Thanks, > > Keith > AG6AZ > > Sent from my iPhone please excuse typos > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net/ > Please help support this email list: http://www.qsl.net/donate.html > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
