I just added KBPF3, KRX3 and KPA3 to my K3 which already had KAT3 and KXV3A. All looks good until I tried to perform the RF Calibrate from the Utility Calibrate Tab. All firmware is current and the utility is latest version on OS-X. I tried two different dummy loads and two different cables to AT1. The calibrate runs clean at the lower frequencies but stops at : Calibrating at 10.125 MHz SWR 10.1:1 is too high for calibration Verify that a dummy load is attached to AN1 5W calibration failed. I did this ok previously before adding the new options. Any ideas? Thanks, Don KA1KU ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected]
This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
