A brief followup: this only occurs with the DL1. I tried it just now going through my LDG antenna switch to a dummy load, and everything works as it should.
As I originally said, it's just a quirk specific to my DL1. 73, Mike, KW1ND On 10/19/2012 09:13 PM, Mike wrote: > Has anyone seen a KX3 high current warning on 6 meters, but only at 5.0 > watts? > 4.8 & 5.2 watts are fine - just at 5.0 watts. > > My setup: MCU 1.23, DSP 0.99, ATU in bypass, DL1 dummy load directly connected > via a double-male BNC, in CW or USB (haven't tested other modes). The display > shows a 1.4:1 SWR in bypass. With the ATU in auto, I get a 1.1:1 and no > issues. > > This isn't related to the lower-current PA mode, as that changeover occurs > above > 3.0 watts in USB. The error message appears independent of which current mode > the PA is in at 5.0 watts, depending on the transmission mode. > > No other bands exhibit this. > > It's not a problem, just a peculiar quirk. > > 73, > > Mike, KW1ND > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
