Sorry, I gave mis-information because of my cursory view of the question.
For the K2, you must use the special cable that is shown in the KIO2 manual. That cable must connect RXD and TXD and *no* other RS-232 signals to the KIO2 connector. Once you have constructed the KIO2 cable, you can connect a standard serial cable to the "computer end" - there are no wires for other than the TXD and RXD signals, so no danger. Bottom line, do not connect any USB to serial adapter directly to the KIO2 or the KPA100 -- the special cable must be used at the KIO2 end. 73, Don W3FPR On 11/9/2012 8:33 PM, Don Wilhelm wrote: > Stan, > > You certainly can use that same cable with the K3. In fact, with the > K3, you can use a standard straight thru serial cable with the K3 (do > not try that with the K2). > If you have standard serial ports on your computer, use them, they are > less troublesome than the USB to serial adapters. > > 73, > Don W3FPR > > On 11/9/2012 7:46 PM, stan levandowski wrote: >> I have a K2/10. I also have a K3/10. If I purchase the KIO2 option for >> the K2 can I use the same USB-Serial adapter cable I'm using with the K3 >> or do I have to buy the "KUSB" product listed right below it on the >> Elecraft Order page. >> >> Thanks and 73, >> >> Stan WB2LQF >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
