I purchased this unit used ( nice workmanship) and it seems to work well in
all respects
except as noted below. I must add that the prior owner told me up front that
there
was an issue with its power. However, when I first put it online line it seemed
to work ok.
Originally I used it with my K2/100 to drive a Mirage D1010 (100w) in ssb
mode. As
time passed, the unit started to show signs of loss of power similar to a high
swr turn back
or high heat shutoff and I attributed it to a failing relay in the Mirage,
which I cleaned and the
system seemed to again work ok for a while. After a reoccurrence, I switched
to another rig
for my 432 activities and let the XV432 sit on the shelf while I mulled the
issue.
I now have a Flex 5000 online and in the process of interfacing the XV432 with
good results
except for the old issue again and I'm determined to figure out the problem
since it really seems
to be the transverter and not the K2 or Mirage.
The setup;
Flex 5000
Single coax interface
RCA keyline
XV432
Bird 43 (25W slug)
Bird dummy load
Here's what I've found;
1) As I start the Flexs' drive, the XV432 output turns on at 0w then continues
to increase to 2.5w
then 'shuts off' and power drops to 0.
2) As I continue to increase the drive, the output power again turns on at
about 15w and increases to 20w +.
I've looked all over the internet for a similar problem but don't find
anything. Maybe someone out there
can point me in the right direction before really hitting the books and at my
age gray matter is in short supply ;0).
Thanks in advance for any help.
73
Tom
W4TMW
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
