Fred,
The KXAT3 does remember the setting on each band segment. I cannot
recall the width of the band segments, but I suggest you do a TUNE on
the bottom of each band, then move up 20 kHz and do a TUNE again.
When you go back to that same band segment, the tuning combination
should be recalled automatically with no additional operations on your part.
If you do a TUNE again (at that point in time) the KXAT3 will initiate a
new tune cycle and throw away the previously remembered values. In
other words, do not do an additional TUNE unless you change antennas.
73,
Don W3FPR
On 2/5/2013 5:32 PM, Fred Carvalho wrote:
Is there any documentation on ATU which explains how it stores antenna
matching parameters in its memory, if it ever does ?
It seems to me that after actioning on the ATU and getting a good match on
a given frequency, when I get back to it again, after tuning on some other
bands, using the same antenna, it losts the antenna info and needs to be
re-tuned. Is it how it works ?
Thanks Fred
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
