But not as a PTT signal (that was the question). DIGOUT1 is either permanently on or off, depending on band-specific menu setting. To use it as a band-specific PTT output is not possible.
73, Olli - DH8BQA Am 16.02.2013 um 09:30 schrieb Edward R Cole <[email protected]>: > Richard, > > Yes, DIGOUT-1 can be used on any band by enabling it in CONFIG: to "ON". > > 73, Ed - KL7UW > --------------------------------------------------------- > Date: Thu, 14 Feb 2013 18:00:26 -0800 > From: Richard Thorpe <[email protected]> > To: [email protected] > Subject: [Elecraft] DIGOUT1 > Message-ID: <[email protected]> > Content-Type: text/plain; charset=us-ascii > > Can I use DIGOUT1 ( pin 11 ACC connector) to key an external 2 meter amp ( > ground on transmit) connected to ANT 3. When I PTT I want to key the 2 meter > amp without keying the 160-10 amp connected to ANT1. Thank you > > K6CG > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
