I use a simple Y cable in my key line and a toggle switch in a small enclosure to key my 350w 2m amp in and out. Had everything needed in junk box to construct, took less than 5 min to make up.
73, Fred/N0AZZ -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Edward R Cole Sent: Saturday, February 16, 2013 3:10 AM To: Jim Rhodes; Oliver Dröse Cc: Elecraft Reflector Subject: Re: [Elecraft] (no subject) Yes, DIGOUT1 is enabled by band. One can use it to enable switch which can be controlled by KEYOUT. 73, Ed - KL7UW At 11:56 PM 2/15/2013, Jim Rhodes wrote: >I have been thinking of using this logic to switch the PTT output with >a relay to the proper amp. Has anyone done this to give me a headstart >on the project? > >Jim K0XU Sent from my Xoom tablet >On Feb 16, 2013 2:46 AM, "Oliver Dröse" ><<mailto:[email protected]>[email protected]> wrote: >But not as a PTT signal (that was the question). >DIGOUT1 is either permanently on or off, depending on band-specific >menu setting. To use it as a band-specific PTT output is not possible. > >73, Olli - DH8BQA > > > > >Am 16.02.2013 um 09:30 schrieb Edward R Cole ><<mailto:[email protected]>[email protected]>: > > > Richard, > > > > Yes, DIGOUT-1 can be used on any band by enabling it in CONFIG: to "ON". > > > > 73, Ed - KL7UW > > --------------------------------------------------------- > > Date: Thu, 14 Feb 2013 18:00:26 -0800 > > From: Richard Thorpe <<mailto:[email protected]>[email protected]> > > To: <mailto:[email protected]>[email protected] > > Subject: [Elecraft] DIGOUT1 > > Message-ID: > <<mailto:[email protected]>C76BE011-3B1A-487 > [email protected]> > > Content-Type: text/plain; charset=us-ascii > > > > Can I use DIGOUT1 ( pin 11 ACC connector) to > key an external 2 meter amp ( ground on > transmit) connected to ANT 3. When I PTT I want to key the 2 meter > amp without keying the > 160-10 amp connected to ANT1. Thank you > > > > K6CG > > > > ______________________________________________________________ > > Elecraft mailing list > > Home: > <http://mailman.qth.net/mailman/listinfo/elecraft>http://mailman.qth.n > et/mailman/listinfo/elecraft > > Help: > > <http://mailman.qth.net/mmfaq.htm>http://mailman.qth.net/mmfaq.htm > > Post: mailto:[email protected] > > > > This list hosted by: <http://www.qsl.net>http://www.qsl.net > > Please help support this email list: > <http://www.qsl.net/donate.html>http://www.qsl.net/donate.html >______________________________________________________________ >Elecraft mailing list >Home: ><http://mailman.qth.net/mailman/listinfo/elecraft>http://mailman.qth.ne >t/mailman/listinfo/elecraft >Help: ><http://mailman.qth.net/mmfaq.htm>http://mailman.qth.net/mmfaq.htm >Post: mailto:[email protected] > >This list hosted by: <http://www.qsl.net>http://www.qsl.net >Please help support this email list: ><http://www.qsl.net/donate.html>http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
